That Bosch is also excellent and probably even better than the PC, the Porter Cable routers are at Lowes, but I had trouble finding one at the...
Buy Porter Cable, Mastercrapt has been junk since the late 1970's. I'm in Toronto, PM if you need a handing finding something good.
What... no new work since mid-October? Here's my latest, just went out the door two weeks ago. It's all Honduras, set neck with an ebony board...
If you end up ordering a set of dwg's from the source above, pay extra to have them shipped rolled up, a set of folded drawings is just such a...
You have nothing to lose by trying the simplest and most effective method, wet the concave side repeatedly so it swells on that side and torques...
Where are you located?
[IMG] Sorry, camera dead and iphone takes poor pics but it's all I have right now...
What... isn't someone going to at least criticize my method or me personally or something?... can of worms perhaps?
IMO, NGR or non-grain-raising alcohol based stains are not meant to apply directly to raw wood, that is a formula for a splotchy disaster, it's...
I clamped the poplar blocks end to end, dry, then glued (hot hide) and clamped the splines into place, without getting any glue on the poplar...
Very good advice, spraying straight retarder can not only amalgamate a finish, it's not detectable once dry - one of the finishers oldest tricks.
IMO the strength of the spline (when glued into a mortise and fully supported) is a good representation of how much strength they add to a joint....
Well that's also an interesting proposition that may give a different viewpoint, but I'm not sure it's necessary, thinking about what the added...
Ok so here's the plan, feel free to comment; I have 6 pieces of poplar cut to 2 1/2" x 6" x 3/4" thick, each has two dados cut on the tablesaw...
Well thanks but I'm not arguing with anyone, certainly not someone on another site because that isn't my link and I'm not talking to him, we're...
Separate names with a comma.