Owner Inexperienced In Replacing Machine Tuners . . . Diy Or Seek Professional?

Discussion in 'Off Topic' started by Jeffrey, Jun 11, 2019 at 5:22 PM.

  1. Jeffrey

    Jeffrey New Member

    Joined:
    May 6, 2016
    Messages:
    21
    Likes Received:
    0
    Tuners worn . . .

    Considering DIY with either manufacturer's machine tuners or better ratio secondary market.

    If no drilling is required, is this something that can be done on own after I watch several YT demos?

    The tuners have top nut/washer; the rear has single screw attachment.

    Professional job, or doable on own?

    Not sure how to match up, hole diameter, with secondary market tuners--no fine-measurement equipment. Manufacturer item would best match without issue, but not sure of original quality.

    I'm thinking, go with manufacturer part; it may not be best ratio but only way to have exact match.

    Thoughts, please--DIY or professional job.

    Thank you, Jeff Fletcher.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice